www.baldormotion.com
C-2 CE & UL MN1942
D.1.3 Declaration of conformity
EC Declaration of Conformity
Date: 21/01/08 Ref: DE00021-001
Manufacturer: Baldor UK Limited
Address
: Mint Motion Centre, Hawkley Drive, Bristol Dist ribution Centre, Bristol, BS32 0BF, United Kingdom
Hereby declare that the product:
MicroFlex E100 Single-Axis Servo Drive, being one of:
MFE230A0XXX
(where XXX = product variant)
when used in accordance with the guidance given in the corresponding MicroFlex E100 Installation Manual, MN1942,
conforms with the protection requirements of the following Council Directives, by application of the relevant harmonized
standards:
The Electromagnetic Compatibility Direct ive 2004/108/EC
and its amending directives:
Standard
:
EN61800-3:2004
Title:
Adjustable speed electrical power drive systems Part 3: EMC Requirements and
specific test methods.
The Low Voltage Directive 2006/95/EC
and its amending directives:
Standard:
EN61800-5-1:2007
Title:
Adjustable speed electrical power drive systems. Safety requirements. Electrical,
thermal and energy.
EN61800-2:1998 Adjustable speed electrical power drive systems. General requirements. Rating
specifications for low voltage adjustable frequency a.c. power drive systems.
EN50178:1997 Electronic equipment for use in power installations.
EN60529:1991+A1 Specification for degrees of protection provided by enclosures (IP code).
EC Declaration of Incorporation
The Machinery Directive 98/37/EC and its amending directives:
The above product is intended to be incorporated into machinery or to be assembled with other machinery to constitute
machinery covered by directive 98/37/EC. As such does therefore not in every respect comply with the provisions of
directive 98/37/EC.
User must follow the guidance given in this direct ive to meet all necessary protection requirements. All instructions,
warnings & safety information of the product manual MN1942 must be adhered to. User must follow the guidance given in
harmonized standard EN60204-1 (Safety of Machinery) to meet necessary protection requirements of this directive.
Furthermore it is declared that it may not be put into service before the machinery in which it will be incorporat ed is
declared to comply with the provisions of directive 98/37/EC, as amended.
Signed:
Dr. Gerry Boast
Engineering Manager
To Next Page
Loading...
