www.baldormotion.com
Configuration 6-3MN1942
6.2.3 Installing the USB driver
It is now necessary to install the USB driver. When the MicroFlex e100 is powered, Windows
(2000 or XP only) will automatically detect the controller and request the driver. The driver
consists of two files, USBmotion.inf and USBmotion.sys. Both files must be present for
installation.
1. Follow the on-screen instructions to select and install the driver. The driver files are available
on the supplied Baldor Motion Toolkit CD. If you are using a copy of the driver located on the
hard disk, a floppy disk or another CD, the two driver files must be in the same folder.
2. During installation, Windows XP may report that the driver is ‘unsigned’. This is normal for the
MicroFlex e100 driver, so click the Continue Anyway button to continue with the installation.
When installation is complete, a new USB Motion Controller device will be listed in the
Universal Serial Bus controllers section of Windows Device Manager .
The MicroFlex e100 is now ready to be configured using Mint W orkBench.
Note: If the MicroFlex e100 is later connected to a dif ferent USB port on the host computer,
Windows may report that it has found new hardware. Either install the driver files
again for the new USB port, or connect the MicroFlex e100 to the original USB port
where it will be recognized in the usual way.
To Next Page
Loading...
