Baldor MicroFlex e100 - V Control Circuit Supply Input (X2)

www.baldormotion.com
Specifications 8-3MN1942
8.1.2 24 V control circuit supply input (X2)
Unit 3A 6A 9A
Nominal input voltage VDC 24
Minimum input voltage 20
Maximum input voltage 30
Maximum ripple % ±10
Maximum continuous current @24 VDC A 0.6
Power on surge current (typical )
@24 VDC, 100 ms
A 4
8.1.3 Motor output power (X1)
Unit 3A 6A 9A
Nominal phase current A
RMS
3 6 9
Peak phase current
for 3 s
A
RMS
6 12 18
Nominal output
@ 230 V, 3Φ
VA 1195 2390 3585
Output voltage range (line-line)
@VDC-bus=320 V
V
RMS
0 - 230
Output frequency Hz 0 - 2000
Output dV/d t
at drive, phase-phase
at drive, phase-ground
at motor (using 20 m cable), phase-phase
at motor (using 20 m cable), phase-ground
kV/μs
2
1.1
1.9
1.8
Nominal switching frequency kHz 8.0
Minimum motor inducta nce (per winding) mH 1
Efficiency % >95
8.1.4 Regeneration (X1)
Unit 3A 6A 9A
Nominal switching threshold (typical) VDC on: 388, off: 376
Nominal power
(10% power cycle, R = 57 Ω)
kW 0.25
Peak power
(10% power cycle, R = 57 Ω)
kW 2.7
Maximum regeneration switching current A
PK
10
Minimum load resistance Ω 39
Maximum load induct a nce μH 100