Baldor MicroFlex e100 - Tools and Miscellaneous Hardware; Other Information Needed for Installation

www.baldormotion.com
3-2 Basic Installation MN1942
H A PC with the following specification:
Minimum specification Recommended specification
Processor Intel PentiumIII
500 MHz
Intel PentiumIII / 4 or equivalent
1 GHz or faster
RAM 128 MB 1GB
Hard disk space 50 MB 50 MB
CD-ROM ACD-ROMdrive
Communication USB port or Ethernet* port
Screen 1024 x 768, 16-bit color 1152 x 864, 16-bit color
Mouse A mouse or similar pointing device
Operating
system
Windows 2000, Windows XP or Windows Vista
* The Ethernet configuration used by a normal of fice PC is not suitable for direct
communication with the MicroFlex e100. It is recommended to install a separate dedicated
Ethernet adapter in the PC, which can be configured for use with the MicroFlex e100. See
section 6.2.4.
3.1.3 Tools and miscellaneous hardware
H Your PC operating system user manual might be useful if you are not familiar with Windows.
H Small screwdriver(s) with a blade width of 3 mm or less for connector X1, and 2.5 mm
(1/10 in) or less for connector X3.
H M5 screws or bolts for mounting the MicroFlex e100.
3.1.4 Other information needed for installation
This information is useful (but not essential) to complete the installation:
H The data sheet or manual provided with your motor, describing the wiring information of the
motor cables/connectors.
H Knowledge of whether the digital input signals will be ‘Active Low’ or ‘Active High’.