5-8 Operation MN1957
www.baldormotion.com
3. In the Select Controller dialog, go to the drop down box near the top and select the PC
serial port to which the NextMove ESB-2 is connected.
(If you are unsure which PC serial port is connected to the NextMove ESB-2, select
Scan all serial ports. During the detection process, a dialog box may be displayed to tell
you that Mint WorkBench has detected new firmware. Click OK to continue.)
Click Scan to search for the NextMove ESB-2.
When the search is complete, click on NextMove ESB-2 in the list to highlight it, and click
Select.
Note: If the NextMove ESB-2 is not listed, check the USB or serial lead between the
NextMove ESB-2 and the PC. Check that the NextMove ESB-2 is powered
correctly. Click Scan to re-scan the ports.
When detection is complete, Fine-tuning mode will be displayed.
Servo Systems Co. • 115 Main Road • P.O. Box 97 • Montville, NJ,
07045-0097 • (973) 335-1007 • Toll Free: (800) 922-1103
Fax: (973) 335-1661 • www.servosystems.com
To Next Page
Loading...
Need help?
General
