ALPHA 2 Pro™ Wave Operator’s Instruction Manual
MKT-AH-1CC40ST [A] 1
Overview
This document provides operating instructions for the ALPHA 2
Pro™ Wave (AH-1CC40ST).
Your machine displays only the features supported by your
software version, jurisdiction, and machine configuration. All
features do not display on every machine. If any feature does not
apply to your machine, then go to the next section.
Prerequisites
This installation may require the following additional items:
• Locks (quantity 5 to 9, depending on your machine
configuration)
• Category 5 network cables (quantity and length depending
on your machine configuration and your floor plan layout)
• Tools for locks
• 22 mm (7/8-inch), 11 mm (7/16-inch), and 10 mm
(0.39-inch) socket or wrench
•Nut Driver
• Needle nose pliers
• Phillips head screw driver
• Alpha Game Platform™ Software Setup Field Guide for your
machine operating system software version
CAUTION
This document may describe procedures for
equipment that does not apply to all cabinet
configurations, or that may require additional
components. Each regulatory jurisdiction may
have controls, policies, and procedures that you
must follow. You are responsible for
understanding and abiding by the rules that apply
in your environment.
MKT-AH-1CC40ST.book Page 1 Friday, November 15, 2013 3:47 PM
To Next Page
Loading...
