610-HB-0503-05 1
CONTENTS.....................................................................1
GENERAL INTRODUCTION TO B&G NETWORK .........2
INTRODUCTION TO NETWORK QUAD.........................3
EXAMPLE SYSTEMS USING NETWORK QUAD...........4
SELECTING THE DISPLAY MODE ................................5
USING THE SPEED KEY................................................6
CALIBRATION AND OPERATING PARAMETERS ........7
SETTING THE DISPLAY DAMPING...............................8
SETTING THE SPEED AND LOG UNITS.......................9
SPEED AND LOG CALIBRATION................................10
1 - MANUAL CALIBRATION - CAL................................11
2 - MANUAL CALIBRATION - LOG CAL .......................12
3 - AUTOMATIC CALIBRATION - AUTO CAL...............13
RESETTING THE DEAD RECKONED DISTANCE .......15
USING THE DEPTH KEY..............................................16
THE DEPTH DATUM - CAL...........................................17
SETTING THE DEPTH DATUM ....................................18
SETTING THE DEPTH UNITS ......................................19
DEPTH ALARMS ..........................................................20
SHALLOW ALARM
ENABLING/DISABLING THE SHALLOW ALARM.........21
ADJUSTING THE SHALLOW ALARM VALUE..............21
DEEP ALARM
ENABLING/DISABLING THE DEEP ALARM .................22
ADJUSTING THE DEEP ALARM VALUE ......................22
ANCHOR ALARM
USING THE ANCHOR ALARM......................................23
ENABLING/DISABLING THE ANCHOR ALARM ...........24
ADJUSTING THE ANCHOR ALARM SHALLOW LIMIT.25
ADJUSTING THE ANCHOR ALARM DEEP LIMIT.........25
USING THE TIMER/TEMP KEY ....................................26
RESETTING THE TRIP LOG.........................................27
SETTING THE TIMERS AND LAP TIMER.....................28
SETTING THE TEMPERATURE UNITS ........................29
CALIBRATING THE TEMPERATURE SENSOR............30
USING THE LIGHTS KEY .............................................31
NETWORK ALARMS.....................................................32
FAULT AND ERROR MESSAGES.................................33
INSTALLATION.............................................................34
SITING THE UNIT..........................................................34
MOUNTING THE UNIT ..................................................34
SPECIFICATION............................................................36
CONTENTS
To Next Page
Need help?
General
