Operation manual
Bär SmartControl 2.0
40000001186_EN_03.docx Page 9 / 39 Date: 31/03/2020
3.2 System components
3.3 Bär SmartControl 2.0 receiver, Mat. no. 200008756
The Bär SmartControl 2.0 receiver is built into the
Cargolift. The receiver establishes the connection
between eBC Controller Pro and Bär SmartControl 2.0
hand-held transmitter, as well as the Bär SmartControl
2.0 docking station. Communication between the receiver
and eBC Controller Pro is by means of CAN bus protocol.
The receiver is connected to the CAN2 connector of the
eBC Controller Pro.
If the connection cable of the Bär SmartControl 2.0
receiver is too short, it can be extended with the
4x0.75/Molex extension cable 4/4
Mat.no. 200007663.
If the Bär SmartControl 2.0 receiver is not installed in the
beam, the SmartControl 2.0 EVO receiver holder Mat. no.
200008990 must be used.
To Next Page
Loading...