bar SmartControl 2.0 - Selection of the Basic Functions

Operation manual
Bär SmartControl 2.0
40000001186_EN_03.docx Page 29 / 39 Date: 31/03/2020
7.2 Selection of the basic functions
Entry
Display
Description
Prerequisites
or
- Hand-held transmitter is located in the reduced
near field, in the near or working field.
- Hand-held transmitter is located in the docking
station
(only relevant for cabin control).
- Release signal for selecting functions is present
(only relevant for cabin control).
- Hand-held transmitter is logged in.
- In the last 5 seconds no function was selected
via another control element.
Lift
 Press the “Lift” pushbutton 2 x then hold it down.
 The “Lift” function is executed until the
pushbutton is released.
If the “Lift” function has been successfully performed and
no other pushbutton has been pressed in the meantime,
the function can be selected by pressing the “Lift”
pushbutton again within 10 seconds of releasing it.
 Press and hold down the “Lift” pushbutton.
 The “Lift” function is executed until the
pushbutton is released.
Lower
 Press the “Lower” pushbutton 2 x then hold it
down.
 The “Lower” function is executed until the
pushbutton is released.
If the “Lower” function has been successfully performed
and no other pushbutton has been pressed in the
meantime, the function can be selected by pressing the
“Lower” pushbutton again within 10 seconds of releasing
it.
 Press and hold down the “Lower” pushbutton.
 The “Lower” function is executed until the
pushbutton is released.
2x+h
1x+h
2x+h
1x+h