Operation manual
Bär SmartControl 2.0
40000001186_EN_03.docx Page 30 / 39 Date: 31/03/2020
Press the “Close” pushbutton 2 x then hold it
down.
The “Close” function is executed until the
pushbutton is released.
If platform in horizontal position (
+
/
-
10°) for more
than 10 seconds:
Enable the “Close” function with 2 brief presses
of the 4-function pushbutton.
Press the “Close” pushbutton 2 x then hold it
down within 10 seconds.
If the “Close” function has been successfully performed
and no other pushbutton has been pressed in the
meantime, the function can be selected by pressing the
“Close” pushbutton again within 10 seconds of releasing
it.
Press and hold down the “Close” pushbutton.
The “Close” function is executed until the
pushbutton is released.
The platform closes to an angle of 45° and then
stops.
Danger!
Risk of crushing between
platform and body!
Ensure that there are no persons in the danger
area before completely closing the platform.
Completely closing the platform:
Ensure that the hand-held transmitter is located
in the near field.
Select the “Close” function again.
The platform closes completely.
Press the “Open” pushbutton 2 x then hold it
down.
If platform in horizontal position (
+
/
-
10°) for more
than 10 seconds:
Enable the “Open” function with 2 brief presses of
the 4-function pushbutton.
Press the “Open” pushbutton 2 x then hold it
down within 10 seconds.
If the “Open” function has been successfully performed
and no other pushbutton has been pressed in the
meantime, the function can be selected by pressing the
“Open” pushbutton again within 10 seconds of releasing
it.
Press and hold the “Open” pushbutton.
The “Open” function is executed until the
pushbutton is released.
If the hand-held transmitter is in the docking station and the Open or Close function is selected with the
platform horizontal, these functions do not need to be enabled beforehand using the 4-function
pushbutton.
To Next Page
Loading...