Operation manual
Bär SmartControl 2.0
40000001186_EN_03.docx Page 13 / 39 Date: 31/03/2020
3.5.3 Bär SmartControl 2.0, Classic Batt hand-held transmitter Mat. no. 200008452
The Bär SmartControl 2.0 Classic Batt hand-held transmitter largely corresponds to the hand-
held transmitter of the Bär SmartControl remote control. With this hand-held transmitter the
Cargolift can be switched on and off via the truck or trailer pushbutton. In addition, the basic
functions “Lift”, “Lower”, “Close” and “Open” can be selected using the corresponding
pushbuttons. If the platform is in a horizontal position, the “Close” and “Open” functions can only
be selected if they have been enabled using the 4-function pushbutton. The “Function”
pushbutton activates the RadioKey function. The hand-held transmitter is powered by two AAA
batteries.
3.5.4 Bär SmartControl 2.0 Plus Batt hand-held transmitter, Mat. no. 200008454
The Bär SmartControl 2.0 Plus Batt hand-held transmitter offers the full range of functions of the
Bär SmartControl 2.0 system without the additional functions provided by the docking station.
With this hand-held transmitter the Cargolift can be switched on and off via the truck or trailer
pushbutton. In addition, the basic functions “Lift”, “Lower”, “Close” and “Open” can be selected
using the corresponding pushbuttons. If the platform is in a horizontal position, the “Close” and
“Open” functions can only be selected if they have been enabled using the 4-function
pushbutton. If the 4-function pushbutton is held for longer than one second, the “Drive In” and
“Drive Out” functions can then be selected. Press the function pushbutton to activate the
“RadioKey” function or double-click this pushbutton to pre-select additional functions such as “Drive In/Drive
Out jack legs”. The hand-held transmitter is powered by two AAA batteries.
3.5.5 Bär SmartControl 2.0 Plus accumulator hand-held transmitter, Mat. no. 200008469
The Bär SmartControl 2.0 Plus accumulator hand-held transmitter offers the full range of
functions of the Bär SmartControl 2.0 system. With this hand-held transmitter the Cargolift can
be switched on and off via the truck or trailer pushbutton. In addition, the basic functions “Lift”,
“Lower”, “Close” and “Open” can be selected using the corresponding pushbuttons. If the
platform is in a horizontal position, the “Close” and “Open” functions can only be selected if they
have been enabled using the 4-function pushbutton. If the 4-function pushbutton is held for
longer than one second, the “Drive In” and “Drive Out” functions can then be selected. Press the
function pushbutton to activate the “RadioKey” function or double-click this pushbutton to pre-
select additional functions such as “Drive In/Drive Out jack legs”. The hand-held transmitter is powered by
two AAA accumulators. To charge the accumulators, the hand-held transmitter can be placed in the docking
station. In addition, the Bär SmartControl 2.0 hand-held transmitter accumulator is equipped with charging
electronics. The charging process is inductive. If the hand-held transmitter is placed in the docking station, it
transmits the feedback signal of the Cargolift (or the Cargolifts if it is a truck and trailer unit).
To Next Page
Loading...