bar SmartControl 2.0 - Optional Functions

Operation manual
Bär SmartControl 2.0
40000001186_EN_03.docx Page 33 / 39 Date: 31/03/2020
7.3.3 Optional functions
Entry
Display
Description
Prerequisites
or
- The Cargolift has additional options such as single
jack legs, central jack legs, under run bar or
customer functions.
- Hand-held transmitter is logged in.
- In the last 5 seconds no function was selected via
another control element.
Activating the
optional mode
or
Activating the optional mode:
 Press function pushbutton briefly 2 x.
 The red LED below the F: symbol flashes, first
function (Jack leg 1) is pre-selected.
 To select the optional function:
Press the function pushbutton until the desired
function is active.
 LED of the selected function illuminates.
Jack leg 1
Drive out:
Drive in:
or
The Drive In/Drive Out Jack leg 1 option is only possible if
the Cargolift has the “Single jack leg” option.
 Activating the optional mode.
 Jack leg 1 option is active.
To drive out the jack leg:
 Press the “Lower” pushbutton 2 x then hold it down.
 The jack leg drives out until the pushbutton is
released.
To drive in the jack leg:
 Press the “Lift” pushbutton 2 x then hold it down.
 The jack leg drives in until the pushbutton is
released.
Jack legs 1 & 2
Drive out:
Drive in:
or
The “Drive In/Drive Out Jack legs 1 & 2” option is only
possible if the Cargolift has the “Central jack leg” option.
 Activating the optional mode.
 To select the “Jack leg 1 & 2” option: Press function
pushbutton briefly 2 x.
 Jack leg 1 & 2 LEDs illuminate.
To drive out the jack legs:
 Press the “Lower” pushbutton 2 x then hold it down.
 The jack legs drive out until the pushbutton is
released.
To drive in the jack legs:
 Press the “Lift” pushbutton 2 x then hold it down.
 The jack legs drive in until the pushbutton is
released.
2x
2x+h
2x+h
2x+h
2x+h
1x