Operation manual
Bär SmartControl 2.0
40000001186_EN_03.docx Page 16 / 39 Date: 31/03/2020
4 Mounting
Only the receiver of the SmartControl 2.0 system is mounted or premounted ex works with certain Cargolift models. The
hand-held transmitter and, if present, the docking station are included in the mounting material. The mounting of the
receiver in the various fitting positions and the checking and preparation of the components for the mounting material are
described in the following.
4.1 Mounting the receiver
The receiver of the SmartControl 2.0 system is installed in different fitting positions on the Cargolift depending
on the Cargolift model. It generally applies that if the eBC Controller is installed in the beam, the receiver must
also be installed in the beam. Cargolifts for left-hand traffic are an exception. In this case the receiver is always
installed behind the Bär Control EVO or the control box on the left in the direction of travel. The receiver in
Cargolifts without beams is always mounted behind the Bär Control EVO or the control box on the side facing
away from the road. The receiver of BusLifts and VanLifts is attached in the provided location on the lifting
mechanism.
The “SmartControl radio 433 Mhz information sign” label Mat. no. 200002995 must always be
attached to all Cargolifts which are equipped with a SmartControl 2.0 system in accordance
with the document describing the labelling of Bär Cargolifts A7305023.
4.1.1 Mounting in Cargolifts with beams
1. Stick a 40mm strip of rubber sponge Mat. no. 101132687 to the side of the receiver without LEDs.
2. Raise the hinge and slide the cable of the receiver into the beam through the centre opening in the
lower area.
3. Move the hinge into the horizontal position (Attention: the hinge lock must be folded in, otherwise it
may be damaged) and lay the cable in the beam in a wide arc.
4. Plug the receiver cable into the CAN 2 port.
5. Attach the receiver cable to the strain relief using a cable tie.
6. Slide the receiver into the holder on the protection cover Mat. no. 200003664 with the side with the
LEDs on it facing the outside.
7. Slide the protection cover onto the hinge of the eBC Controller Pro.
8. Raise the protection cover and engage the lock.
9. Slide the cable of the receiver into the beam until it is touching the protection cover.
It must be ensured that the protection cover can be pulled off with the receiver slid into it!
To Next Page
Loading...