bar SmartControl 2.0 - 8 Functions of the Bär Smartcontrol 2.0 System; Checking the Charge Status of the Batteries;Accumulators in the Hand-Held Transmitter; Docking Station Charging Process; Checking the Charging Process of the Hand-Held Transmitter Accumulator

Operation manual
Bär SmartControl 2.0
40000001186_EN_03.docx Page 36 / 39 Date: 31/03/2020
8 Functions of the Bär SmartControl 2.0 system
8.1 Checking the charge status of the batteries/accumulators in the hand-held
transmitter
Entry
Display
Description
The following prerequisites apply for checking the charge status
of the batteries/accumulators in the hand-held transmitter:
- The hand-held transmitter is not located in the docking
station.
- The hand-held transmitter is not logged in
To check the charge status:
 Press and hold down the “Stop” pushbutton for at least 1
second.
 As long as the pushbutton is pressed, the first 9 LEDs
indicate the charge status as shown.
 If the battery LED blinks:
The charge status of the batteries/accumulators is < 20
%.
8.2 Docking station charging process
 To charge the accumulator: Insert the hand-held transmitter into the docking station.
 The accumulator is charging: The red LED illuminates for 30 seconds after insertion.
 The accumulator is charged: The red LED flashes for 30 seconds after insertion.
8.3 Checking the charging process of the hand-held transmitter accumulator
Entry
Display
Description
The following prerequisites apply for checking the charge status
of the accumulators in the hand-held transmitter:
- The hand-held transmitter is located in the docking
station.
- The hand-held transmitter is not logged in.
To check the activity of the charging function:
 Press and hold down the “Stop” pushbutton for at least 1
second.
 As long as the pushbutton is pressed, the LED under the
battery symbol indicates the charge status.
 Charging function active:
LED under the battery symbol illuminates.
 Charging function inactive:
LED under the battery symbol blinks.
h >1s
1x
h >1s
1x