Operation manual
Bär SmartControl 2.0
40000001186_EN_03.docx Page 14 / 39 Date: 31/03/2020
3.6 Bär SmartControl 2.0 docking station, Mat. no. 200005754
The Bär SmartControl 2.0 docking station is installed in the cabin by the body
manufacturer or the end customer. The docking station is the charging station of
the Bär SmartControl 2.0 Plus accumulator hand-held transmitter. In addition, the
docking station has a loss protection function. The docking station is connected to
the receiver via radio. This means that hand-held transmitters that are inserted into
the docking station can be paired with the respective Cargolift. This function is
called EasyPairing.
If the vehicle has a rear view camera system, this can be integrated into the Bär
SmartControl 2.0 system via the docking station. This makes it possible to
implement cabin control using a hand-held transmitter. For this purpose, control
signals must be exchanged between the docking station and the camera system.
The control connection on the docking station is available for this purpose. If the
respective control signal is not present here, operation of the inserted hand-held
transmitter is not enabled.
The following cables are available so that the docking station can be electrically
integrated into the driver's cabin.
The Bär SmartControl 2.0 docking station is directly integrated into the vehicle
electrical system with the cable “Cable 4 x 0.75 / Docking Station Direct” Mat. no.
200007666.
This cable can be found in the mounting material with the docking station when the
Cargolift is delivered.
The cable “Cable 2 x 0.75 / Docking Station car plug” Mat. no. 200007678 is used
to connect the docking station to the vehicle's cigarette lighter.
This cable is only available by request, and is not included in the Cargolift delivery.
The assembly company is responsible for the proper and professional mounting of the docking station, as well
as for observing and complying with the applicable laws and standards or the mounting guidelines.
To Next Page
Loading...