bar SmartControl 2.0 - Hand-Held Transmitter in Docking Station

Operation manual
Bär SmartControl 2.0
40000001186_EN_03.docx Page 28 / 39 Date: 31/03/2020
7.1.2 Hand-held transmitter in docking station
Entry
Display
Description
The following prerequisites apply for logging in:
- The hand-held transmitter is paired with the system.
- The docking station is paired with the system.
- The hand-held transmitter is located in the docking
station.
- No other hand-held transmitter is logged in to the system.
or
The system is built into the truck:
 Press “Truck” pushbutton briefly 2 x.
 The green LED and red LED under the truck symbol
illuminate dimly.
 If logging in is successful:
The red LED under the truck symbol illuminates brightly.
 Control voltage on Cargolift is switched on.
The system is built into the trailer:
 Press “Trailer” pushbutton briefly 2 x.
 The green LED and red LED under the trailer symbol
illuminate dimly.
 If logging in is successful:
The red LED under the trailer symbol illuminates brightly.
 Control voltage on Cargolift is switched on.
The system on the trailer must be paired with the system on
the truck.
or
If the release signal for the cabin control is present, the green
LED illuminates. The selection of functions is enabled.
2x
2x