bar SmartControl 2.0 - Page 35

Operation manual
Bär SmartControl 2.0
40000001186_EN_03.docx Page 34 / 39 Date: 31/03/2020
Jack leg 2
Drive out:
Drive in:
or
The Drive In/Drive Out Jack leg 2 option is only possible if
the Cargolift has the “Single jack leg” option.
 Activating the optional mode.
 To select the Jack leg 2 option:
Press the function pushbutton.
 Jack leg 2 LED illuminates.
To drive out the jack leg:
 Press the “Lower” pushbutton 2 x then hold it down.
 The jack leg drives out until the pushbutton is
released.
To drive in the jack leg:
 Press the “Lift” pushbutton 2 x then hold it down.
 The jack leg drives in until the pushbutton is
released.
Under
run bar
Drive out:
Drive in:
or
The “Lift/Lower under run bar” option is only possible if the
Cargolift has the “Under run bar” option.
 Activating the optional mode.
 To select the “Under run bar” option:
Press function pushbutton briefly 3 x.
 “Under run bar” LED illuminates.
To lower the under run bar:
 Press the “Lower” pushbutton 2 x then hold it down.
 The under run bar lowers until the pushbutton is
released.
To lift the under run bar:
 Press the “Lift” pushbutton 2 x then hold it down.
 The under run bar lifts until the pushbutton is
released.
Customer functions
Function A:
Function B:
Function C:
Function D:
or
The “Customer functions” option is only possible if the
Cargolift has the “Customer function” option.
 Activating the optional mode.
 To select the Customer functions option: Press
function pushbutton briefly 4 x.
 “Customer function” LED illuminates.
To execute the customer function:
 Press the “Lift”/ “Lower”/ “Close”/ “Open” pushbutton
2 x briefly.
 The customer function is executed.
No customer functions are currently available.
Deactivating
the optional
mode
or
The optional mode is deactivated when:
- no pushbutton is actuated for longer than 7
seconds.
2x+h
2x+h
2x
2x+h
2x+h
3x
2x
2x
2x
2x
4x