4. Daily operation
Switching on the display w hile it is in stand-by mode or vice versa can both be done by
using the keys or by using the control wheel.
To switch your display on using the keys:
1. Light up the keys indicator lights as previously described.
2. While the keys are light up, touch the Stand-by/Cancel key for approximately 2 seconds.
As a result, the display will switch on and the power status indicator light is dimmed.
To switch your display on using the c ontrol wheel:
1. Press the control wheel for approximately 2 seconds.
As a result, the display will switch on and the power status indicator light is dimmed.
The power LED can be disabled in the OSD menus. Please refer to "Power status indi-
cator li ght", page 20 for detailed instructions on how to do this.
To switch your display to Stand-by using the keys:
1. Light up the keys indicator lights as previously described.
2. While the keys are light up, touch the Stand-by/Cancel key, a small window pops-up. Press the button
again to confirm.
As a result, the display will switch to stand-by mode and the power status indicator light is orange.
To switch your d isplay to Stand-by using the control wheel:
1. Press the control wheel once, a small window pops-up. Press the control wheel again t
oconfirm.
As a result, the display will switch to stand-by mode and the power status indicator light is orange.
In case of a power outage recovery, your display will always start-up in the power mode
it wa s in before the power interruption (i.e. stand-by or on). This protects your display
against inadvertent image retention problems.
4.4 Bringi ng up the OSD menus
About OSD menu
TheOSDmenuallowsyoutoconfigure different settings to make your Coronis Fusion 10MP display fit
your needs within your working environment. Also, you can retrieve general information about your display
and its current configuration settings through the OSD menu.
Bringing up the OSD menus can be done by using the keys or by using the control wheel.
How to bring up the OSD menus using the keys
1. If not already done so, switch on the display as previously described.
2. Light up the keys indicator lights as previously desc
ribed.
3. While the keys light up, touch the Menu/Enter key.
As a result, the OSD main menu comes up in the bottom right corner of the screen. If no further actions
are taken within the following 90 seconds however, the OSD menu will disappear again.
K5902031 CORONIS FUSION 10MP 28/08/2013
17