3. Display installation
4. Unscrew the four fixation screws fixing the panel to the stand.
5. Attach the panel firmly to the arm using 4 screws M4 x 10 mm.
3.9 F irst time starting up
Overview
You are now ready to start up your Coronis Fusion 10MP for the first time.
1. Switch on your Coronis Fusion 10MP as described in "Stand-by switching", page 16.
2. Turn on the computer connected to your display.
If you have properly installed your display and display controller, the Windows start-up messages will
appear once the boot procedure is finished.
Your Coronis Fusion 10MP w ill be running in a basic vide o mode at a default refresh rate
when first time starting up. If you are using a Barco display controller, please consult
the user guide delivered with it to install the drivers, software and documentation. When
this is done, your display will automatically detect the connected video input signal(s)
and apply the correct video mode and refresh rate.
14 K5902031 CORONIS FUSION 10MP 28/08/2013
To Next Page
Loading...
