BARIX Barionet User Manual

B A R I O N E T
Document Name: Barionet Hands-on Training Guide
Document ID: 20131017SG2
Document Date: 17. Oct. 2013
Document Version: 1.31
Firmware name: Barionet
FW Release Date:
Package Name:
HANDS-ON TRAINING GUIDE

BARIX Barionet Specifications

General

Category	Controller
Network Interface	Ethernet
Ethernet Ports	1
Digital Inputs	8
Flash Memory	8 MB
Model	Barionet
Ethernet	10/100 Mbit
Digital Outputs	8
Protocol Support	Modbus TCP
CPU	ARM

Summary

2 Hardware Interfaces Usage

2.1 Digital Input Usage

Describes how to use digital inputs, which can be ON (1) or OFF (0), with different connection methods.

2.2 Analog Input Usage

2.3 Relay Usage and Wiring

2.4 Digital Output Usage

2.5 Barix Temperature Sensor Connection

3 Control Interface Usage

3.1 TCP Control Interface

Instructions on using the TCP control interface via Telnet applications for remote control.

3.2 UDP Control Interface

Details on using the UDP control interface, offering advantages for multiple network clients.

3.3 HTTP/CGI Control Interface

Explains how to control the Barionet using the HTTP/CGI interface via a web browser.

3.4 SNMP Control Interface

Information on using the SNMP protocol for reading/writing Barionet registers and receiving traps.

3.5 Modbus Communication

Methods for communicating with Modbus devices, either directly or via the Barionet as a serial gateway.

4 Register Value Conversion

5 Connecting Extension Units

5.1 Wiring Extension Units

Step-by-step wiring instructions for connecting extension units to Barionet50 and Barionet100 models.

5.2 Required BCL Applications

5.3 Loading BCL Applications

5.4 Barionet Extension Addressing Tool