3 How to use the control interfaces
On the Barionet homepage some of the hardware IOs can be controlled.
Only over the Control interfaces you have access to all IO registers. Over
these Control interfaces it´s possible to switch outputs, read the input
registers/states or check other Barionet information.
The following Control interfaces are available:
- TCP
- UDP
- HTTP / CGI
- SNMP
- Modbus/TCP
Other interfaces and commands can be added over the BCL programming
language.
3.1 How to use the TCP control interface ?
To use the TCP control interface any Telnet application can be used, like
Telnet command from command prompt, Teraterm, Hyperterminal and so on.
But before it can be used it must be enabled in the Barionet setup under
“CONTROL” - TCP Command Port, there define any port number, e.g. 12302
.
BARIX AG | 17. Oct. 2013 | Barionet Hands-on Training Guide | Page 15/38
To Next Page