BARIX Barionet - Default Chapter; Table of Contents

Table of Content
1 Introduction................................................................................4
1.1 About “Barionet”..................................................................................................4
1.2 About this manual.................................................................................................4
1.3 Product features (Interfaces)..............................................................................5
2 How to use the hardware interfaces.....................................6
2.1 How to use the digital inputs ?..........................................................................6
2.1.1 Connecting the input directly to input ground.................................7
2.1.2 Using digital input with a switch / button...........................................8
2.1.3 Using digital input with a sensor...........................................................9
2.2 How to use the analog inputs ?.......................................................................10
2.3 How to use / wire a relay ?..............................................................................11
2.4 How to use a digital output ?..........................................................................12
2.5 How to use / connect a Barix Temp sensor ?.............................................13
3 How to use the control interfaces.......................................15
3.1 How to use the TCP control interface ?......................................................15
3.2 How to use the UDP control interface ?.....................................................17
3.3 How to use the HTTP/CGI control interface ?..........................................20
3.4 How to use the SNMP control interface ?...................................................21
3.5 How to communicate with Modbus ?...........................................................21
4 How to convert register values............................................23
4.1 Converting analog register value....................................................................23
4.2 Converting temperature register value........................................................23
5 How to connect extension units to the Barionet..............24
5.1 Wiring....................................................................................................................25
5.1.1 Barionet50................................................................................................25
5.1.2 Barionet100.............................................................................................25
BARIX AG | 17. Oct. 2013 | Barionet Hands-on Training Guide | Page 2/38