Up to 50 temperature sensors can be connected and will be supported from
the Barionet.
The temperature value (in °C) of the first 8 sensors will be displayed on the
Barionet´s homepage, the values from all temperature sensors can be
requested from the Barionet registers also.
Information about reading the values from the Barionet registers and
converting the register values you can find in chapter 4.
On the Barionet50 also any other 1-wire sensors can be used, but in this
case all the 1-wire communication must be programmed over BCL (for more
information see BCL programmers manual).
BARIX AG | 17. Oct. 2013 | Barionet Hands-on Training Guide | Page 14/38
To Next Page