Barko Hydraulics 930 - Safety While Servicing

page 58page 58

page 58

930/937 Mulcher (O)

800-00256

SAFETY WHILE SERVICINGSAFETY WHILE SERVICING

SAFETY WHILE SERVICING

The following maintenance section gives suggested guidelines for operational maintenance on your machine. In

severe conditions (extreme dust, heat, cold, humidity, etc.) you will need to service your machine more often. Your

experience will dictate a more severe servicing program.

Safety while servicing your machine is your responsibility. Only qualified and authorized personnel should be

permitted to maintain, repair, adjust and inspect the machine.

Read and understand the warnings and safety precautions in the Safety Summary and elsewhere in this manual

before doing any service on the machine. The following precautions should be used as a reminder to safe servicing.

WARNINGWARNING

WARNING

Always shut down the machine and lower theAlways shut down the machine and lower the

Always shut down the machine and lower the

mulching attachment to the ground beforemulching attachment to the ground before

mulching attachment to the ground before

working on the machine. If necessary to work onworking on the machine. If necessary to work on

working on the machine. If necessary to work on

a lifted mulcher attachment, securely support thea lifted mulcher attachment, securely support the

a lifted mulcher attachment, securely support the

attachment so that it cannot move or fall in anyattachment so that it cannot move or fall in any

attachment so that it cannot move or fall in any

way.way.

way.

CAUTIONCAUTION

CAUTION

Do not leave loose tools and rags on theDo not leave loose tools and rags on the

Do not leave loose tools and rags on the

machine. Ensure that all walking and climbingmachine. Ensure that all walking and climbing

machine. Ensure that all walking and climbing

surfaces are clean.surfaces are clean.

surfaces are clean.

WARNINGWARNING

WARNING

Handle fuel carefully. Do not smoke while fillingHandle fuel carefully. Do not smoke while filling

Handle fuel carefully. Do not smoke while filling

fuel tank or working near fuel.fuel tank or working near fuel.

fuel tank or working near fuel.

Refer to Fluid Specifications wheneverRefer to Fluid Specifications whenever

Refer to Fluid Specifications whenever

replacing oils, fluids, or filling fuel tank.replacing oils, fluids, or filling fuel tank.

replacing oils, fluids, or filling fuel tank.

WARNINGWARNING

WARNING

Do not weld on any structural member unlessDo not weld on any structural member unless

Do not weld on any structural member unless

specifically authorized by Barko Hydraulics.specifically authorized by Barko Hydraulics.

specifically authorized by Barko Hydraulics.

Any unauthorized welding or welding proceduresAny unauthorized welding or welding procedures

Any unauthorized welding or welding procedures

will void the warranty, and may cause death,will void the warranty, and may cause death,

will void the warranty, and may cause death,

severe injury, property damage or structuralsevere injury, property damage or structural

severe injury, property damage or structural

damage to the machine.damage to the machine.

damage to the machine.

WARNINGWARNING

WARNING

Do not support the machine on cinder blocks,Do not support the machine on cinder blocks,

Do not support the machine on cinder blocks,

hollow tiles, or props that may crumble under ahollow tiles, or props that may crumble under a

hollow tiles, or props that may crumble under a

load. Do not work under a machine that isload. Do not work under a machine that is

load. Do not work under a machine that is

supported solely by a jack.supported solely by a jack.

supported solely by a jack.

CAUTIONCAUTION

CAUTION

Check the Hour Meter regularly to determineCheck the Hour Meter regularly to determine

Check the Hour Meter regularly to determine

when the machine needs periodic maintenance.when the machine needs periodic maintenance.

when the machine needs periodic maintenance.

Use the intervals on the Service ScheduleUse the intervals on the Service Schedule

Use the intervals on the Service Schedule

except when operating in extreme conditions;except when operating in extreme conditions;

except when operating in extreme conditions;

then shorter intervals must be used.then shorter intervals must be used.

then shorter intervals must be used.

WARNINGWARNING

WARNING

Under no circumstances should anyUnder no circumstances should any

Under no circumstances should any

modifications be made to Barko machinerymodifications be made to Barko machinery

modifications be made to Barko machinery

without factory authorization. Any modificationswithout factory authorization. Any modifications

without factory authorization. Any modifications

may void the warranty. This machine wasmay void the warranty. This machine was

may void the warranty. This machine was

designed to do a specific job and alterationsdesigned to do a specific job and alterations

designed to do a specific job and alterations

could result in death, severe injury or propertycould result in death, severe injury or property

could result in death, severe injury or property

damage.damage.

damage.

CAUTIONCAUTION

CAUTION

Do not exceed 15 PSI nozzle pressure whenDo not exceed 15 PSI nozzle pressure when

Do not exceed 15 PSI nozzle pressure when

drying parts with compressed air. Do not directdrying parts with compressed air. Do not direct

drying parts with compressed air. Do not direct

compressed air against human skin. Seriouscompressed air against human skin. Serious

compressed air against human skin. Serious

injury could result.injury could result.

injury could result.

REMEMBER: SAFETY FIRST!REMEMBER: SAFETY FIRST!

REMEMBER: SAFETY FIRST!

Barko Hydraulics 930 - Safety While Servicing

Table of Contents

Other manuals for Barko Hydraulics 930

Related product manuals