page 59page 59
page 59page 59
page 59
930/937 Mulcher (O)
800-00256
WELDINGWELDING
WELDINGWELDING
WELDING
Procedure for Welding on 930 with Cummins engineProcedure for Welding on 930 with Cummins engine
Procedure for Welding on 930 with Cummins engineProcedure for Welding on 930 with Cummins engine
Procedure for Welding on 930 with Cummins engine
Disconnect positive and negative battery terminals
Disconnect the 3 connectors (one 4 Pin, and two 50 pin) plugged into engine ECM on left side
of engine (right side of machine). [This removes the possibility of current traveling through the
ECM grounds.]
Disconnect 14 Pin Engine Harness Connector from back right side of cab. (This is the Lower
Right Plug) [This removes the ground going to the cab electrical panel]
Ground as close as possible to the welding location. Do NOT ground through a bearing or
bushing when welding.
Procedure for Welding on 930 / 937 with John Deere engineProcedure for Welding on 930 / 937 with John Deere engine
Procedure for Welding on 930 / 937 with John Deere engineProcedure for Welding on 930 / 937 with John Deere engine
Procedure for Welding on 930 / 937 with John Deere engine
Disconnect positive and negative battery terminals
Disconnect the two connectors plugged into engine ECU on right side of engine (left side of
machine). There is a release button on the bottom of the plug, and then the latch rotates
90degrees. [This removes the possibility of current traveling through the ECU ground.]
Disconnect 14 Pin Engine Harness Connector from back right side of cab. (This is the Lower
Right Plug) [This removes the ground going to the cab electrical panel]
Ground as close as possible to the welding location. Do NOT ground through a bearing or
bushing when welding
To Next Page
Loading...
