Basler racer User Manual

AW00118508000 Acquisition Control
Basler racer Camera Link 95
1. Select the source signal for frequency conversion by setting the related value of the Frequency
Converter Signal Source register.
2. Set the desired frequency value of the Frequency Converter Pre Divider register.
3. If you want to perform signal alignment (see above) you can set the value of the Frequency
Converter Signal Alignment register.
4. To avoid overtriggering, Basler recommends to set the Frequency Converter Prevent
Overtrigger register to 1.
5. Set the desired frequency value of the Frequency Converter Multiplier register.
6. Set the desired frequency value of the Frequency Converter Post Divider register.
For more information about direct register access, see Section 3.2 on page 28.
To set the parameters needed to configure the frequency converter module via direct
register access:

Basler racer Specifications

General

Brand	Basler
Model	racer
Category	Digital Camera
Language	English