AW00118508000 Specifications, Requirements, and Precautions
Basler racer Camera Link 23
1.12 Precautions
DANGER
Electric Shock Hazard
Non-approved power supplies may cause electric shock. Serious injury or death
may occur.
You must use a camera power supply which meets the Safety Extra Low Voltage
(SELV) and Limited Power Source (LPS) requirements.
WARNING
Fire Hazard
Non-approved power supplies may cause fire and burns.
You must use a camera power supply which meets the Limited Power Source
(LPS) requirements.
NOTICE
Dust on the sensor can impair the camera’s performance.
The camera is shipped with a protective plastic seal on the camera front. To avoid collecting dust
on the camera’s sensor, make sure that you always put the protective seal in place when there is
no lens mounted on the camera.
Also, make sure to always point the camera downward when there is no protective seal on the
camera front or no lens mounted.
Never apply compressed air to the camera. This can easily contaminate optical components,
particularly the sensor.
NOTICE
Inappropriate code may cause unexpected camera behavior.
The code snippets provided in this manual are included as sample code only. Inappropriate
code may cause your camera to function differently than expected and may compromise
your application.
To ensure that the snippets will work properly in your application, you must adjust them to
meet your specific needs and must test them thoroughly prior to use.
To Next Page
Loading...
Need help?
General
