Baur Sys compact 2000 M pro - Page 94

Index Syscompact 2000 M pro
94
/ 98 822-175-2
Evaluating SIM/MIM reflection images
• 62
Evaluating TDR reflection images • 56
Evaluating the ICM transient image •
69
F
Fault indication with status LEDs • 87
Faults and corrective measures • 87
Faults on the IRG 2000 • 88
For your safety • 10
Forbidden for persons with
pacemakers • 11
Full illustration of Syscompact 2000 M
pro • 19
G
Guaranteeing immediate measures in
an emergency • 16
I
ICM
Impulse current method • 64
Instructions for the operator • 10
Intended use • 10
IRG 2000 time domain reflectometer •
21
IRG 2000 user interface • 24
M
Maintenance and care • 79
Maintenance schedule • 80
Markings on the system • 27
Maximum permissible output current
in DC voltage mode • 15
N
No operation during condensation •
12
No operation in areas with risk of
explosion and fire • 12
Note on the screenshots and graphics
used • 9
O
On the IRG 2000 • 54, 56, 60, 62, 66,
68
On the system control panel • 60, 61,
62, 66, 67, 68, 74
Operating states of a testing system
with Syscompact 2000 M pro • 25
Operation only in a technical secure
state • 11
Overview of the available cable fault
location methods • 18
P
Packaging • 31
Performing acoustic pin-pointing • 73
Performing ICM measurements • 67
Performing the cable test • 50
Performing the SIM/MIM
measurement • 61
Performing the TDR measurement •
55
Placing the IRG 2000 into the system
• 42
Placing the system in the road traffic
area • 34
Positioning the zero cursor • 45
Preparing the test object terminals •
34
Prerequisites • 35, 38, 50, 55, 61, 67,
73
Printing measurement data • 45
Procedure • 35, 38, 51, 56, 61, 67, 74
Procedure during evaluation • 57
Product information • 18
Putting the testing system out of
operation • 75
R
Rating plate on the IRG 2000 time
domain reflectometer • 28
Recommendation if the fault position
is not easily visible • 58, 70
Recommendations if the fault position
is not easily visible • 63
Regular calibration • 86