BA series pumps
Pump unit with diesel drive 1401
8.16
WARNING
Never use any spray starting aids.
Preparations for starting
– Set speed control lever „1“ to a position between 1/2
START and max. START, according to requirements.
Selecting a lower engine speed will reduce smoke
when starting.
– Make sure that stop lever „2“ - if fitted - is in the
operating „START“ position.
Starting
Starting procedure
1. Perform the starting preparations.
2. Follow the starting procedure, as described in section 9.5.
WARNING
Never attempt to start a running engine.
Danger of breaking teeth off the flywheel or
starter motor pinion.
Important!
If the engine is equipped with a starter motor protection module,
before attempting to restart the engine you must return to
position 1 for at least eight seconds after a failed starting
attempt or after the engine has been stopped.
To Next Page
Loading...