Page 1-34 MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Detailed Component Descriptions
Chapter 1: Introduction
By using the Web pages, you can configure or browse the following options
(refer to table 1-7 on page 1-34 and table 1-8 on page 1-34).
Table 1-7. Configuring Options Available for the Area Alarm by Using the
Web Pages
Table 1-8. Browsing Options Available for the Area Alarm by Using the
Web Pages
Option Description
Active Area Alarms Lists all of the active Area Alarm Modules.
Detailed information about this
Area Alarm
Lists type of gas, gas reading, units of measure, and
location of Area Alarm Modules.
Master Alarms on this network
List of Master Alarms communicating with this
Area Alarm.
Event log Log of events and alarms for this Area Alarm.
Model identification
Software version, device location, and device name
used by the Information Systems personnel.
Network statistics
Communication statistics used by Information
Systems personnel.
Option Description
User administrators Sets up to three users.
Set clock Sets the real time clock.
Device name
Sets a unique name to the Area Alarm Network
Communications Board.
Location
Sets the location of the room that the module is monitor-
ing.
Direction
Sets the direction of the wing that the module is moni-
toring.
Alarm return time Sets the time between audible alarms.
Network setup Sets the Ethernet network settings.
Software update Programs the Area Alarm’s FLASH software.
To Next Page
