TX-1xx Series Printer Operation Manual
~ 23 ~
immediately, if not specified in this manual, all for this operation; Another kind
is to press and hold the key more than two seconds and then to release, the
following called "long press".
： In the standby mode for most of operation modes, press this key
can enter the sample name and lot number, about the sample name
and lot number, please refer to Section 8.10; In settings / input state,
this key can move the input position to the left. Marked as "[Fn1]"
or “[LEFT]” in this manual.
： Press this key, can open the related functions of the current
operation mode; In the standby mode for most of operation modes,
long press this key, can enable or disable the automatic tare
function, about the function of automatic tare, please refer to
Section 8.9; In Settings/input state, the key can move the input
position to the right. Marked as "[Fn2]" or “[RIGHT]” in this
manual.
： Under standby status, press the key once to feed the printer by one
To Next Page
Loading...