BEL Engineering Mark L - Filters Selection

To Next Page

To Previous Page

14 Filters selection

It is possible to adapt the balance to the different environment conditions thanks to the

selection of three filters:

 FILTER 1: proportion of ingredients condition

 FILTER 2: stable conditions

 FILTER 3: unstable conditions

1. From zero condition on display, press and keep pressed the MENU button until the

acoustic alarm gets mute, then release the button. The message “unitS” is displayed,

then press MENU button until the message “FILTER” is displayed then confirm it by

pressing the PRINT button.

2. Pressing MENU or CAL button it will be possible to scroll forward or backward the

different filtering levels, select the one you wish and then confirm it by pressing the

PRINT button

3. After having selected the filtering level you wish, press the MENU button to go to next

parameter or CAL to go to previous one.

4. To escape from parameters setup menu, press the MENU button until the acoustic

alarm is over, then release the button.

5. The balance will return to standard weighing conditions.

NOTE: It is suggested to use FILTER 1 when proportion of ingredients must be performed