Benelli BN302 - Tyre Check; Head Light Check

92
EN
TYRE CHECK
Use a gauge to check the pressure.
Pressure should be measured while
tyres are cool.
Tyre pressure
Front tyre: 2.4 bar
Back tyre 2.4 bar
• Make sure that there are no frag-
ments of metal, nails or gravel in the
tyre tread. Remove if necessary.
• Check for wear. Replace tyres if the
wear is excessive or irregular. The
depth limit for tread is:
Front tyre: 1.6 mm
Back tyre 1.6 mm
IMPORTANT NOTICE:
Incorrect pressure, or excessive or ir-
regular wear to tyres will reduce vehicle
stability.
G
WEAR LIMIT
HEAD LIGHT CHECK
With the engine running, check the cor-
rect operation of positioning lights, front
and back, the strong and dipped head-
lights and the numberplate light.
Headlamp adjustment
Sit on the vehicle at a distance of 10
metres from a wall. Switch on the high
beam and measure the maximum height
of the lit area.
• Standard height from ground level:
9/10 total height
If the values found are not the same
as the standard measurements, go to
a Benelli assistance centre for adjust-
ment.
h
9/10 h
10 m
CHECKS BEFORE RIDING
INDICE
CHECKS BEFORE RIDING
EN
96