80
EN
MAIN CONTROLS
LEFT DIAL
MAIN CONTROLS
1) High beam / low beam light
control.
Set this switch to “ ” for high beam
lights and to “ ” for low beam lights.
2) Left/right position indicator
switch.
Press this switch to enable the left and
right and rear indicators. Press the centre
to disengage them.
3) Sound warning switch.
Press this switch to enable the sound
alarm.
4) Passing button.
Press this button (daytime) to enable
lashing lights.
5) ABS Switch.
If you want to enable/disable the ABS ,
please keep you motorcycle slower than
5km/h or stop, because the ABS switch
only works when vehicle speed is lower
than 5 km/h.
From ABS ON mode → OFF mode
Please Keep pressing the ABS switch
precisely within the range of 3~5
seconds, the ABS indicator light should
be changed from lit to blink as per 1.27s
(Slow Blink) when you release the
switch.
Now the ABS was turned OFF and the
brake will work as conventional system.
From ABS OFF mode → ON mode
Please keep pressing the ABS switch
precisely within the range of 3~5
seconds, the ABS indicator light should
be changed from blink as per 1.27s
(Slow Blink) to constant lit when you
release the switch.
Or you can turn the power switch off and
on to reset the ABS system to On mode
ABS
~
1
2
3
4
5
To Next Page
Loading...
