Seats
Passenger seat
To remove the passenger seat
1. Insert the key into the seat lock, and then
turn it clockwise.
1. Seat lock
2. Lift the front of the passenger seat and pull
it forward.
To install the passenger seat
1. Insert the projections on the rear of the pas-
senger seat into the seat holders as shown,
and then push the front of the seat down to
lock it in place.
Rider seat
To remove the rider seat
1. Remove the passenger seat.
2. Unscrew the 2 screws.
3. Remove the rider seat.
To install the rider seat
1. Proceed in reverse order.
Adjusting the headlight beams
The headlight beam adjusting knobs are used
to raise or lower the height of the headlight
beams. It may be necessary to adjust the he-
adlight beams to increase visibility and help
prevent blinding oncoming drivers when car-
rying more or less load than usual.
Obey local laws and regulations when adju-
sting the headlights.
To raise the headlight beams, turn the knobs
in direction (A).
To lower the headlight beams, turn the knobs
in direction (B).
1
1
1
2
A A
B B
To Next Page
Loading...
Need help?
General
