SPECIAL TOOLS
The following special tools are necessary for complete and accurate tune-up and assembly.
Use only the appropriate special tools; this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques.
When placing an order, refer to the list provided below to avoid any mistakes.
Weight
Rocker arm shaft puller bolt
These tools are used when removing
or installing the rocker arm shafts.
This tool is used to remove the
flywheel magneto.
This tool is used to loosen and tighten
the exhaust and steering ringnut.
This tool is necessary for adjusting
valve clearance.
This gauge is used to measure the fuel
level in the float chamber.
Radiator cap tester
Adaptor
These tools are used for checking the
cooling system.
T-handle
Damper rod holder
These tool are used for holding the
damper rod holder when removing or
installing the damper rod holder.
Clutch spring compressor
Clutch spring holder arm
These tools are used for removing the
nut with holding the compression spring.
This tool is used when removing or
installing the secondary sheave nut.
To Next Page
