Benelli ZAFFERAN 250 - Battery; Failure Diagnosis

42
Preparing principles
Item
Specifications
Battery
Capacity/Type
12V-6AH/ dry-charged
Voltage
（68F）
Fully charged
13.1V
Necessa
ry
charging
12.3V (not working for 1h)
Charging current
Standard: 0.6A, quick: 6A
Charging time
Standard: 10-15 hours, quick: 30 mins
Alternator
Capacit
y
200W/8500rp
m
Coil impedance（68F）
Between white-black 3.3-3.5Ω
Voltage
regulator
Type
Three-phase full-wave
Charging voltage
14.5±0.5V/5.000rpm
Tightening torque force Tools
Rectifier bolt 5.0 N·m Universal fixing spanner
High-voltage coil fixing bolt 9.0 N·m Flywheel remover
Flywheel fixing nut 5.0 N·m Test instrument
Body guard bolt 9.0 N·m Multimeter
1.2 Failure diagnosis
Power supply dead Interrupted current
Battery over Emission Poor contact of the charging wire
Unconnected battery wiring Poor contact of the charging system
Fuse blow Poor contact or short circuit of the lighting
system Poor switch
Low voltage Poor charging system
Poor battery charging Poor contact, short circuit or open circuit of wire terminals
Poor contact Poor voltage/current regulator
Poor charging system Poor
magneto Poor voltage/current regulator
1.3 Battery
1.3.1 Battery
disassembly Remove the
battery cover. Remove the clamp
assembly.
Remove the negative lead and then the positive
lead. Take out the battery.
Warning!
During the removal of the positive terminal, the
tool should not be contacted with the frame. It
is dangerous that spark caused by short circuit
will ignite petrol and destroy the battery.