Bernard Controls AQ Logic Series - Set Closing Rotation Direction; Set Closing and Opening on Torque or Position

English
27
5.2 Set closing rotation direction
Default setting for closing direction is clockwise. According to your
needs, you may have to change your closing direction.
How to change closing direction
1. Enter the menu, then go to Settings > Actuator
commissioning > Set closing rotation direction.
2. Choose the closing rotation direction required, Clockwise or
Counter-clockwise with

or  then confirm with OK.
3. Go to SAVE with

or  then validate with OK.
5.3 Set closing and opening on torque or position
This section allows you to define the way you want to stop actuator
travel in both directions. You can choose either Position or Torque.
How to set opening and closing type of end of travel
1. Enter the menu, then go to Settings > Actuator
commissioning > Choose to close on torque or position.
2. Select your option with

or  then confirm with OK.
3. Select Save then validate with OK.