Bernard Controls AQ Logic Series User Manual

English
28
5.4 Set torque limits
This setting allows to set torque limits at main steps of the travel:
at the beginning (Break), during the travel (Run) and at the end of
the travel (End).
Limits are:
 In closing direction:
Break to Close (BTC), Run to
Close (RTC), End to Close (ETC),
Tight zone
 In opening direction:
Break to Open (BTO), Run to
Open (RTO), End to Open (ETO),
Tight zone

In order to ensure unsitting, Break value should be upper to
Tight zone one.

Bernard Controls AQ Logic Series Specifications

General

Brand	Bernard Controls
Model	AQ Logic Series
Category	Controller
Language	English