8
3.2.1 Changing closing direction indication
As a standard, AQ actuator is configured to close clockwise. If the
actuator must close counter-clockwise, you can change the
orientation of the position indicator cap.
This change requires to have the actuator software set
accordingly.
To proceed to this setting, see §5.2.
Standard indicator orientation
for clockwise closing
Reverse indicator orientation
for counter-clockwise closing
How to change cap orientation
1. Disassemble the cover then the
cap.
2. Turn the cap 90°.
3. Reassemble the cap then the
cover.
To Next Page
Loading...
