Bernina E 16 PRO - Page 106

106
o The thread feed gear is not in the home position.
· Feeder Prole
o Use the Feeder Prole button to rotate the thread feed motor one full revolution to analyze
the tooth prole of the drive gear and populate the elds below the button.
· Feeder Home Adjust
o When enabled, this allows for a slight adjustment to the rotation of the gear when in the
home position.
o Feeder Home Adjust is enabled
o Feeder Home Adjust is disabled
o The value entered when enabled is the amount of the adjustment.
Status Log
The status log shows the latest captured action of the machine.
Tapping this will open the status log and display a history of actions along with timestamps.