4. If the cap has a braid, move it around the cap to the inside and under the brim.
Hooping the Cap
To hoop the cap,
1. Slide the cap frame onto the cap gauge. Make sure the locating tab on the cap gauge ts into the cap
frame notch and the cap frame slips rmly under the two roller clips. Watch your ngers! Don’t pinch
them between the back of the frame and the gauge.
2. Swing the metal strap open.
3. Place an appropriate stabilizer over the gauge and the teeth of the cap frame. Make sure that the
stabilizer is long enough to support the full embroidery area. It may be easiest to use stabilizer long
enough to reach the posts on the bottom of the cap frame.
To Next Page
Loading...