7. Pull the side of the sweatband toward the cap frame and down. Smooth any bunching of the cap
sides or sweatband. You may eventually need to fold the sweatband a bit to avoid the latching hook.
But this will help with the placement of the cap on the frame. As you do this, watch the stabilizer to
ensure it is still in
8. When the left side of the cap is within the strap hinge post, swing the strap up and over the cap brim.
On the side of the cap, the teeth of the strap should fall just above the seam attaching the sweatband
of to the cap.
9. Continue bringing the strap around the front of the cap. On the front of the cap, the teeth of the strap
must fall into the seam for the bill.
10. Bring the strap down the other side of the cap. Make sure the teeth of the strap fall just above the
stitching attaching the sweat band. This will help ensure a level sewout.
To Next Page
Loading...