The Acti-Feed Minimum is displayed as the lower set line in the Feed Chart.
Maximum
The Acti-Feed Maximum sets an upper limit for the Acti-Feed. It allows the machine to adjust the amount of
thread fed as needed, but it will not allow feeding more than the specied amount. It is uncommon to need
to limit the maximum for the Acti-Feed.
Acti-Feed Suggestions
The Acti-Feed Suggestions can provide a guideline for where the minimum should be set.
Tapping any fabric/garment suggestion populates the slider and Acti-Feed Minimum to a mid-point
suggestion for that material. As even the same type of garment can vary in thickness, you may wish to adjust
the Acti-Feed Minimum a bit more.
Transform (Move & Rotate)
Move and rotate the design within the connes of the selected hoop. This will allow you to adjust the angle or
position of the design.
Moving Through a Design
Occasionally, you will need to move forward or backward within a design. These tools allow you to do that
quickly. They include:
· Seek Back or Seek Forward
o Tapping this button will bring up the option to move through a design 1, 10, or 100 stitches in
a move without stitching.
o Holding the subsequent button will continue the movement at the specied speed.
· Move to Stitch
o Tapping this will open a window with a eld for specifying the exact stitch number you wish to
move to.
To Next Page
Loading...