Bernina E 16 PRO - Page 43

43
· Move to Trim
o Tapping this will bring up a scrollable area with design segments previewed.
o These segments are divided by trims.
o Select the segment to move to and conrm to move through the design to the desired trim
command/start of segment.
· Move to Color
o Tapping this will bring up a scrollable area with design segments previewed.
o These segments are divided by color change commands.
o Select the segment and conrm to move through the design to start of the desired color
block.
Machine Operations
Machine Operations will move or activate dierent functions of the machine often used when embroidering
both during and between runs and jobs. These would include:
· Hoop Forward/Back
o Moves the frame forward as far as possible while leaving the needle within the seweld of the
hoop.
o Tapping again will move the frame back in to the original position.
· Trim Immediate
o Causes the machine to execute a trim command.
· Change to Needle (Move Needle case)
o Tapping this brings up a window displaying the thread tree / needle assignments.
o Selecting the desired needle number and conrming will move the needle case to that needle.
· Laser On / Laser O
o Activates or deactivates the laser for positioning.
· Grabber In / Grabber Out
o Closes and opens the grabber.