Bernina E 16 PRO - Page 59

59
o Eects are displayed as an overlay to a color block. Select the color block to which the eect is
applied.
2. Tap to select the trash button below the color sequence.
o Commands will be removed from the sequence entirely.
o Eects will be removed from the color block, but the color block will remain.
To remove all commands and eects from the color sequence,
1. Tap on the Reset Color Sequence button below the color sequence. This removes all eects and
commands while leaving needle assignments.
Additional Functions
On the bottom of the screen is the grabber function. It exists on this screen for easier access if changing
cones of thread on the machine.
· Grabber In / Grabber Out
o Closes and opens the grabber.
o This is helpful when changing needles or capturing threads in the trap behind the needles.