Bernina E 16 PRO - Page 58

58
§ After an Appliqué command has stopped the machine, starting the machine will move
the hoop back into place and continue sewing the design.
o Pause - Placing this command between color blocks will cause the machine to stop and
wait to be restarted, but it will not move the hoop forward.
§ This command is often placed in designs larger than a single bobbin can sew as a
reminder to replace the bobbin.
· Eects
o Thinner 3D - Placing this eect on a color block will adapt the Acti-Feed of the aected
block for use with thinner 3D embroidery foam (typically 2mm foam).
§ This eect is often preceded by a pause or applique command to place the foam.
o Thinner 3D - Placing this eect on a color block will adapt the Acti-Feed of the aected
block for use with thicker 3D embroidery foam (typically 3mm foam).
§ This eect is often preceded by a pause or applique command to place the foam.
o Looping - Thinner 3D - Placing this eect on a color block will adapt the Acti-Feed of the
aected block for use with thicker thread and intentionally overfeeds, creating loops in the
stitches.
§ This command is often placed in designs that were created for use with this technique
and for use with a thicker, fuzzier thread.
§
Adding/Removing Commands & Eects to the Color Sequence
To add a command or eect to the color sequence,
1. Tap to select the color block in the color sequence.
2. Tap on the command or eect to be added.
o Commands are added after the selected color block and appear with the sequence.
o Eects are added to the selected color block and appear as an overlay to the color block.
To remove a command or eect to be removed from the color sequence,
1. Tap on the command or eect to be removed.
o Commands are displayed and selectable as a block within the sequence.