b. Colors from Design O - If this view option is OFF, the selected color block in the view
window will update to the newly assigned color.
3. Continue by selecting the next color block to change and repeating the rst two steps.
4. Optional - Add any color sequence commands and/or eects desired. See below.
5. Conrm to apply the sequence and exit the screen.
Automatic Color Match
To automatically set the color sequence of the design:
1. Tap the Color Match button below the color sequence.
o This will compare the color information from the design and the colors assigned to needles
and make matches based on those color values. Each color block will be overlaid with a match
evaluation.
§ Distant Match
§ Close Match
2. Review the colors in the color sequence and make changes as desired.
3. Optional - Add any color sequence commands and/or eects desired. See below.
4. Conrm to apply the sequence and exit the screen.
Color Sequence Commands & Eects
On each side of the thread tree are dierent commands and eects that can be applied in a color sequence.
· Interrupt Commands
o Appliqué - Placing this command between color blocks will cause the machine to move
the hoop out as far as possible with the needle still within the hoop limits.
§ This command is often placed after the placement stitch in an appliqué design. This
allows the embroiderer to have easier access to the material without taking the hoop
o of the machine. It also stops the machine automatically instead of the embroiderer
watching the sew-out to stop the machine and place the appliqué material.
To Next Page
Loading...