Bernina E 16 PRO - Page 76

76
4. Conrm the position of the second point by tapping the conrm second point button.
5. Once both points are conrmed, the design is rotated to match the line created by the two
points and the positioning buttons become available. Tapping any one of the following buttons will
dierently position the design in relation to the line created by the two conrmed points.
o Position the bottom of the design on the line and the design origin horizontally aligned to
the rst conrmed point.
o Position the bottom of the design on the line and the design origin horizontally centered
between the rst and second conrmed points.
o Position the bottom of the design on the line and the design origin horizontally aligned to
the second conrmed point.
o Position the design origin horizontal axis on the line and the design origin horizontally
aligned to the rst conrmed point.
o Position the design origin horizontal axis on the line and the design origin horizontally
centered between the rst and second conrmed points.
o Position the design origin horizontal axis on the line and the design origin horizontally
aligned to the second conrmed point.
o Position the top of the design on the line and the design origin horizontally aligned to the
rst conrmed point.
o Position the top of the design on the line and the design origin horizontally centered
between the rst and second conrmed points.
o Position the top of the design on the line and the design origin horizontally aligned to the
second conrmed point.