Uni-Probe LB 491
Berthold Technologies GmbH & Co. KG
3 – 201
Volume 3
3
2.11 REVIEW
The contents and use of this information can only be changed par-
tially by the user; for the most part, they are defaulted by Berthold
Tech no lo gie s.
MODEL
Shows the model number of the Uni-Probe. This information is
defaulted by Berthold Technologies and cannot be changed.
DISTRIBUTOR
Shows the name of the distributor of the Uni-Probe. This informa-
tion is defaulted by Berthold Technologies and cannot be changed.
MANUFACTURER
Shows the manufacturer (Berthold Technologies) of the Uni-Probe.
This information cannot be changed.
DEVICE ID
Device identification number. It shows the specific HART
®
ID num-
ber. This information is defaulted by Berthold Technologies and
cannot be changed.
Sensor Serial No
Shows the serial number of the sensor. This information is
defaulted by Berthold Technologies and cannot be changed.
TAG
Shows the tag number. This text can be used by the operator as
desired. This information can be changed on the
GENERAL DATA
menu (see page 3–206).
DESCRIPTOR
Shows a descriptor code. This text can be used by the operator as
desired. This information can be changed on the
GENERAL DATA
menu (see page 3–206).
MESSAGE
Shows a message. This text can be used by the operator as
desired. This information can be changed on the
GENERAL DATA
menu (see page 3–206).
ASSEMBLY NO
Identification number of the measurement device.
To Next Page
